Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: 2.4ghz in my airboat?  (Read 1937 times)

Patrick Henry

  • Guest
2.4ghz in my airboat?
« on: April 30, 2010, 09:54:09 am »
I'm presuming that my GiantCod 2.4ghz radio will be ok to use in my airboat? The rx is set above the waterline with the little aerial wire at about 45 degrees as I can't get it vertical unless I poke it out through the deck, which I suppose I could do...run it up a short plastic tube and put a plastic cap over the end.

I can't see why it won't be ok, but I'd welcome some input before I complete the installation...


Rich
Logged

Martin (Admin)

  • Administrator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 23,845
  • Location: Peterborough, UK
    • Model Boat Mayhem
Re: 2.4ghz in my airboat?
« Reply #1 on: April 30, 2010, 10:03:52 am »
Should be, they've been using them in model aeroplanes for years.
Logged
"This is my firm opinion, but what do I know?!" -  Visit the Mayhem FaceBook Groups!  &  Giant Models

Patrick Henry

  • Guest
Re: 2.4ghz in my airboat?
« Reply #2 on: April 30, 2010, 10:06:19 am »
That's good news Martin, thanks for that...installation will continue then.
Logged

john54

  • Guest
Re: 2.4ghz in my airboat?
« Reply #3 on: April 30, 2010, 03:33:38 pm »
With the Planet 5 (The Same ?) i have found it does not matter what angle the ant is  ok2  As for range if you can see it you can normally control it  ;)
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.097 seconds with 22 queries.