Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: 1 [2]   Go Down

Author Topic: Digital caliper Battery?!?!  (Read 14988 times)

tigertiger

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 6,604
  • Location: Kunming, city of eternal springtime, SW China.
Re: Digital caliper Battery?!?!
« Reply #25 on: September 06, 2018, 10:29:22 AM »

I had a similar problem with mine. The problem was caused by the foam box lining pressing the 'On' button when I closed the case, or stored the case on its edge (caliper leaning on its side against the foam). Now the foam has flattened a little (I could have helped this with a knife) and I store the case flat on the shelf, the problem has gone.
Logged
The only stupid question is the one I didn't ask

Brian60

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 3,172
  • Location: Hull,UK-but currently residing in Los Martinez, Spain.
Re: Digital caliper Battery?!?!
« Reply #26 on: September 06, 2018, 12:15:40 PM »

No that doesn't work Bill, even though the auto shut off works, the battery is still flat after 3/4 days, so it may be a short someplace?
But what I didn't make clear is that you can use any thickness battery as long as diameter is correct - just leave off the battery cover, which I had been doing because of the constant need to remove the battery.

bgrunes

  • Shipmate
  • *
  • Offline Offline
  • Posts: 15
  • Location: Crosby Liverpool
    • Crosby Model Boat Club
Re: Digital caliper Battery?!?!
« Reply #27 on: September 06, 2018, 09:34:59 PM »

Same problem good point on the foam pressing the button. Will leave battery out from now on. Thanks
Logged

derekwarner_decoy

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 7,564
  • Location: Wollongong Australia
Re: Digital caliper Battery?!?!
« Reply #28 on: September 06, 2018, 10:48:27 PM »

I have a digital G Clamp.....alas a hunk of iron fell on the face & smashed the display  <*<

On further inspection it was not the display as such but a piece of glass covering the actual electronic pad

The on/off button does not work  >>:-(......but the display just blinks......2 seconds with mm......2 seconds with the dimension

The UOM [units of measurement] button between " & mm also works

That was about 2 years ago.......battery is still powering up the device......day in ...day out

Seems such a waste to condemn it to the bin :P

The image captured confirms the mm displayed but no digits...bit it's OK..... I know they will show up in a sec
Logged
Derek Warner

Honorary Secretary [Retired]
Illawarra Live Steamers Co-op
Australia
www.ils.org.au

john mantova

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 214
  • Model Boat Mayhem is Great!
  • Location: Meliden N. Wales
Re: Digital caliper Battery?!?!
« Reply #29 on: September 07, 2018, 12:20:37 AM »

I just saved a lady of my acquaintance 480 pounds by being able to change batteries in her Honda car keys. Honda couldn't open them 'cause one had a rusty screw and one a damaged head. They wanted to charge her 240 each for new ones.Robbing  swine.I drilled the head off one and will drill it out later  The other one I got the screw out and drilled it out for a 7BA  nut and bolt. Made the nut captive with Gorilla glue. Used plastic magic as a primer as it is an odd plastic but Plastic Magic seems to stick anything plastic except polythene types. The batteries? Well one was 2 but 5 for 3:66 Panasonic CR1616 should last a bit if she keeps them in the fridge. Slightly off topic but I thought it worth a mention
Logged

john mantova

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 214
  • Model Boat Mayhem is Great!
  • Location: Meliden N. Wales
Re: Digital caliper Battery?!?!
« Reply #30 on: September 07, 2018, 12:28:28 AM »

The foam could have been shrunk with a quick flash of a lighter flame. Magic
Logged
Pages: 1 [2]   Go Up