Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: electronic speed controllers  (Read 1717 times)

boatmadman

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,703
  • Location: South Cumbria
electronic speed controllers
« on: February 15, 2007, 08:25:14 pm »
Hi,
Any one used these type of controllers? Any good or bad comments?

Hitec - EZX-R Reversing Speed Controller

found them here:

http://www.pandanmodelboats.co.uk/acatalog/Our_Online_Catalogue_Hitec_Electronic_Speed_Controllers_238.html

Ian
Logged
if at first you dont succeed.....have a beer.....

HS93 (RIP)

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,922
  • I cannot spell , tough
  • Location: Rainhill UK
Re: electronic speed controllers
« Reply #1 on: February 15, 2007, 08:32:21 pm »
They are OK ,But they are really a car/buggy controller and  will only do a MAX of 8.4 volts. A lot of boat people what to use 12 volt sla batteries ,so they may limit you depending on the type of model you want to use it in . Peter
Logged

boatmadman

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,703
  • Location: South Cumbria
Re: electronic speed controllers
« Reply #2 on: February 15, 2007, 08:33:50 pm »
Hi,
Was thinking about use for my riva, where a bit of sauntering with the occasional high speed run is the order.

Ian
Logged
if at first you dont succeed.....have a beer.....
Pages: [1]   Go Up
« previous next »
 

Page created in 0.101 seconds with 21 queries.