Topic: Paddle engine (Read 567 times)

Hammer · « **on:** December 17, 2011, 11:44:51 AM »

Pictured below my own design twin double oscillator. It can be seen running on http://www.youtube.com/watch?=-ANuLa4jRKQ . If I did that right. Hammer

derekwarner_decoy · « **Reply #1 on:** December 17, 2011, 12:02:03 PM »

I am not sure if this is a joke or...?

...Derek

steamboatmodel · « **Reply #2 on:** December 17, 2011, 04:32:36 PM »

I get the same monkeys as Derek.
Regards,
Gerald.

Hammer · « **Reply #3 on:** December 17, 2011, 09:17:19 PM »

Sorry Derek I have missed out a V. but I am sure you have seen it before. Try this!!! http://www.youtube.com/watch?v=-ANuLa4jRKQ .

Geoff

derekwarner_decoy · « **Reply #4 on:** December 17, 2011, 09:30:12 PM »

Hammer....that slow speed @ say 30 to 60 RPM is quite smooth

...will you add some additional gearing to join the paddle shaft? or prop shaft?........similar to the models displayed by bogstandard......

.....Derek

Hammer · « **Reply #5 on:** December 18, 2011, 07:26:29 PM »

Derek, 3 to 1 gearing. The black X marks the position of servo. Geoff