Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Propalignment thingy  (Read 2072 times)

Norman Castle

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 298
  • Location: Southeast England
Propalignment thingy
« on: December 01, 2015, 06:52:11 pm »
I seem to recall once seeing on the interweb a neat little device for aligning propshafts to motors, but I'm jiggered if I can find it now. 

Any clues, please chaps? 
Logged
A positive attitude may not solve all your problems, but with any luck it will annoy enough people to make the effort worthwhile.

Fastfaz

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 516
  • Model Boat Mayhem is Great!
  • Location: Southport, United Kingdom
Re: Propalignment thingy
« Reply #1 on: December 01, 2015, 07:12:12 pm »
     Have a look at Mobile Marine models site under running gear.
         Cheers,
              Faz. :-)) :-)) :-)) :-)) :-)) :-)) :-))
Logged

Peter Fitness

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 7,376
  • Location: Wyrallah, near Lismore NSW Australia
Re: Propalignment thingy
« Reply #2 on: December 01, 2015, 09:21:48 pm »
I made one up using two pieces of brass tube soldered together, one to fit on the motor shaft and the other on the prop shaft. It works a treat.


Peter.
Logged

Norman Castle

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 298
  • Location: Southeast England
Re: Propalignment thingy
« Reply #3 on: December 02, 2015, 04:20:31 pm »
Cheers Faz, that's what I was looking for  :-)
Logged
A positive attitude may not solve all your problems, but with any luck it will annoy enough people to make the effort worthwhile.
Pages: [1]   Go Up
« previous next »
 

Page created in 0.086 seconds with 21 queries.