Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Binding problem, Planet R7M  (Read 2306 times)

The Old Fart

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 298
  • Model Boat Mayhem is Great!
  • Location: Caister-on-Sea, Norfolk, UK
Binding problem, Planet R7M
« on: August 31, 2016, 04:46:59 pm »
Hi Guys,

I'm having a problem with a Planet R7M receiver.
Binding to a T5.


I go through the binding process, RX on, push button, fast flash, radio on, slow flash, 10seconds, solid led.  Bound ok and works.

Next time I switch on RX it flashes slowly, and 10 seconds later binds to radio again.

Presume it should hold the bind?
Logged

Netleyned

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,051
  • Location: Meridian Line, Mouth of the Humber
    • cleethorpes mba
Re: Binding problem, Planet R7M
« Reply #1 on: August 31, 2016, 05:06:24 pm »
Sounds good to me.
If its taking a few seconds to bind
then thats not a problem.
If you are having to rebind each
switch on then it is.


Ned
Logged
Smooth seas never made skilful sailors
Up Spirits  Stand fast the Holy Ghost.
http://www.cleethorpesmba.co.uk/

john44

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,659
  • member of the Potteries Model boat club
Re: Binding problem, Planet R7M
« Reply #2 on: September 01, 2016, 12:46:52 pm »
Sounds good to me too, l take it that your transmitter is switched on before you
Switch the receiver on. After the initial binding process,
my 7 channel planet Rx,s
Take a bit longer to locate the tx signal but work fine once mated up.


John

Logged

The Old Fart

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 298
  • Model Boat Mayhem is Great!
  • Location: Caister-on-Sea, Norfolk, UK
Re: Binding problem, Planet R7M
« Reply #3 on: September 01, 2016, 08:49:56 pm »
ok thanks,

Logged

The Old Fart

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 298
  • Model Boat Mayhem is Great!
  • Location: Caister-on-Sea, Norfolk, UK
Re: Binding problem, Planet R7M
« Reply #4 on: September 02, 2016, 07:55:54 pm »
Tried another RX, binds and stays bound.
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.103 seconds with 21 queries.