Greetings.
Last summer I managed to find an un-built MH&B Topaz kit. It took a bit to get it from South Africa to Denver, Colorado.
I then had to re-configure my shop in the garage in order to make room on the other half for my wife to park her car.
When I finally got everything ready I discovered that there were some cracks in the hull.
So before I got started those needed repair. I asked in the fiberglass section of this forum on methods of repair
and after following them, I am now ready to start.
The kit is incredibly complete. All the little extras are provided.
I started by an inventory, then I had the drawings mounted on
cardboard to facilitate being handled.
Next I started to separate the pieces and categorize them by where
they go on the boat: Cockpit, Salon, Seating Area, etc.
Here are some pics.
Thanks for reading,
Jim Pope
Denver