Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Making aPreiserWelder figure work set no 10243  (Read 1521 times)

david48

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 866
  • Location: Strathdon,Aberdeenshire
Making aPreiserWelder figure work set no 10243
« on: April 15, 2017, 01:42:58 pm »


I picked a Presser figure set up that has a welder/gas cutter simulation it comes with the resistor wired up , but I require a box of tricks to make it work . If I apply voltage it will just glow blue ,the LEDis the size of a small pin head all cast in to the figure.     
I have a Viessmann switcher for the job , how ever it requires a16v AC so thats a no go .

I have not looked for the parts to build one yet ,if there is a ready made one out there.
Boat using 2 12v sla's


Thanks,  David.       
Logged
Two heads are better than one sheep head  as my old plant manager used to say

barriew

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,111
  • Location: Thaxted, Essex
Logged

david48

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 866
  • Location: Strathdon,Aberdeenshire
Re: Making aPreiserWelder figure work set no 10243
« Reply #2 on: April 16, 2017, 12:30:44 am »


That could be the very thing thanks for that ,at £9its worth a shot.
Cheers Barrie.
David
Logged
Two heads are better than one sheep head  as my old plant manager used to say
Pages: [1]   Go Up
 

Page created in 0.089 seconds with 21 queries.