Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Billings Norden - anyone fitted RC?  (Read 1149 times)

barriew

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,111
  • Location: Thaxted, Essex
Billings Norden - anyone fitted RC?
« on: October 22, 2017, 01:16:01 pm »
I've just acquired a Billing's Norden kit and wondered if anyone had fitted RC to one. It looks as though it will require quite a bit of butchery to do so %) .
 I believe that S T Canute uses a similar construction technique i.e  hull built in two halves, so if anyone has added RC to one of those I would be interested.


Barrie
Logged

timg

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 319
  • Location: east yorks
Re: Billings Norden - anyone fitted RC?
« Reply #1 on: October 22, 2017, 10:29:30 pm »
Hi Barrie


I have built a st canute and fitted r/c  , your right about the hull been built In  two halves, the hull is around 56cm but the norden looks around 35 cm which will be a lot more challenging.
Nice looking model if you can do it
Good luck
Spud
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.102 seconds with 21 queries.