Technical, Techniques, Hints, and Tips > The "Black Arts!" ( Electrics & Electronics )
Ardunio Powered Smoker
timgarrod:
Been messing around with the Smoker I've made with the ardunio powering the fan.
https://youtu.be/EsbWWbqPQPI
Mid Thottle - Min smoke,
Move the Throttle a bit and get full smoke,
full throttle - Min smoke.
Might mess about with it so when the engine sound start up. the fan to rev up and down too.
C-3PO:
Nice one Tim...
Did you make the smoker unit as well or just bolt on the Arduino control?
C-3PO
timgarrod:
Hi C3po.
made the smoker too.
cheers
C-3PO:
Tim,
What type of fan did you use and what voltage is it working at?
Did you use PWM to control speed? and was this via some sort of transistor?
Cheers
C-3PO
timgarrod:
Hi C3po,
the fan is a CPU 12volt fan (not the pwm version)and running it on 6 volt as 12 was to much and pushed the smoke out too quick. I tied the neg wire via a Mosfet to control the speed. Should of listen to good friend along time ago to with this little mosfets instead of relays(cheers John :) ).
The board moved on a little bit, it now controls not just the fan but also the lights.
now i unstand how to use them, will be using them more often.
Will post pic of the board and video of it in the boat for full effect.
cheers
Tim
Navigation
[0] Message Index
[#] Next page
Go to full version