Mess Deck: General Section > Tugs and Towing
Damen Stan Tug 1907 1:72 (3D printed)
Moller62:
The winter print.
Searching for a small tug as a winter project I came accross the Damen Stan tug 1907.
Moller62:
There is no actual kit of this tug in a small size but it's 'offered' as a 3D print here: https://www.youtube.com/watch?v=oz8k-SL4xmU and here: https://www.thingiverse.com/thing:2346104.
I wrote a mail to mr. Ernest aka 'byedesign'.
I got the stl file for 10 $ i think, and ordered a print at a local 3D print shop here in Copenhagen.
The result is here.
Moller62:
The hull was glued with super glue aka cyano acrylat and basic car primer filler was applied.
Moller62:
The propeller shafts
The shafts are expected to be 2mm i diameter in order to fit the printed propellers.
I made my tube/bushings of brass Ø 4/3 mm and Ø 3/2 mm.
The shafts were made along the describtion in http://www.building-model-boats.com/model-boat-propeller-shaft.html .
The dimensions of the shafts are depicted below.
Moller62:
And yes it is your's truly on the double bass - http://allanmeinhardt.dk/trio
Navigation
[0] Message Index
[#] Next page
Go to full version