well ..
finally this year is almost over ..
It started with an illness at the beginning of the year and a necessary operation in the hospital .. after recovering, I went back to my job where I was very busy the whole year .. so I couldn't continue building at all .. thank god it was it was a bit quieter in autumn and I could FINALLY continue building again ..
but i used the recovery time and looked around the net for all sorts of information about the great role model .. and lo and behold ..
I found more than what I was looking for .. !!!!!!!!!
I discovered the following two sides ..
https://matterport.com/de/media/2518https://my.matterport.com/show/?m=n8zEKKbKMaGYOU ARE THE HAMMER .. !!!!!!!!!!
there you can look around virtually on and in the boat and even measure everything ..
I found some details that differ from the blueprint and that I now had to change again.
For example, I redesigned the four flaps over the Y.boat .. this time only from 2mm thick plexiglass and the two middle ones are narrower than the outer ones .. and this time also scaled down ..
and the front and rear support of the panels are now in a slight curve .. just like the curved deck shape ..
I also changed the hinges for the plates .. I soldered the two original holes closed .. and had small circles engraved in the hinges in an engraving shop .. that's five because each hinge is attached with five screws on the original .. and they are then countersunk by the thickness of the hinge so that only the round part stands over the plates .. so it is more true to the original and I like it much better that way ..
it's going on again ..
the squirrel eats idle ..