Technical, Techniques, Hints, and Tips > Tutorials & "How To’s" ...
How to cut freeing Port smoothing
macz_chung:
Hi everyone,
Nice to meet to you all. I'm going to build a tug from model slipway which is AL KHUBAR. I would like to ask how to cut the freeing port accurate ?
What does the tools as i need ? :-)
Thanks
Chung
John W E:
Hi this may help you out :-))
http://www.modelboatmayhem.co.uk/forum/index.php/topic,28028.msg279853.html#msg279853
john
macz_chung:
Hi John,
Thanks your reply. That's great idea for mark the line on bulwarks. The next step should be drill the small hole and use flat file knife to make it smooth ?
tigertiger:
I did something similar for scuppers, which are smaller. Basically cut the hole too small, and then used a piece of sandpaper glued to a flat stick for the edges, and a round file for corners. Just slowly edging out from the hole. Finally a quick clean with very fine sandpaper. NB I don't use the red oxide colored stuff, it stains.
macz_chung:
Hi tiger,
You provide a great method to me for my project.
Thanks
chung
Navigation
[0] Message Index
[#] Next page
Go to full version