Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Servo linkage  (Read 2410 times)

roversean

  • Guest
Servo linkage
« on: April 13, 2009, 02:50:31 pm »
Hi i was wondering do i need to buy a special type of wire to connect my servo to my rudder?
   Many thanks Sean
Logged

Shipmate60

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,868
  • You bark - I will bite!!!
  • Location: Ivverkip, Inverclyde.
Re: Servo linkage
« Reply #1 on: April 13, 2009, 03:02:00 pm »
No, I use brazing wire, but you can buy threaded bar which is thicker steel with a thread on one end to fit the servo ends.
On rudders I connect both sides so 1 side is always pulling so wire in tension.

Bob
Logged
Officially a GOG.

DickyD

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,423
  • www.srcmbc.org.uk
  • Location: Southampton UK
    • SRCMBC
Re: Servo linkage
« Reply #2 on: April 13, 2009, 05:16:58 pm »
Or you can check out this on Cornwall Model Boats web site.

http://www.cornwallmodelboats.co.uk/acatalog/installation_accessories.html
Logged
Richard Solent Radio Controlled Model Boat Club http://www.srcmbc.org.uk

Shipmate60

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 5,868
  • You bark - I will bite!!!
  • Location: Ivverkip, Inverclyde.
Re: Servo linkage
« Reply #3 on: April 13, 2009, 05:28:10 pm »
The top one is what I mentioned Dicky.

Bob
Logged
Officially a GOG.

DickyD

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,423
  • www.srcmbc.org.uk
  • Location: Southampton UK
    • SRCMBC
Re: Servo linkage
« Reply #4 on: April 13, 2009, 05:58:49 pm »
I know Bob, just thought I'd let him see what you were talking about. ok2
Logged
Richard Solent Radio Controlled Model Boat Club http://www.srcmbc.org.uk
Pages: [1]   Go Up
« previous next »
 

Page created in 0.018 seconds with 18 queries.