Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: 1 [2]   Go Down

Author Topic: Rainbow J-Class Yacht Build  (Read 12387 times)

ronkh

  • Guest
Re: Rainbow J-Class Yacht Build
« Reply #25 on: October 09, 2008, 01:31:53 pm »
May seem like overkill but here are a few more. Pick the best if you need them. (Camera is on its last legs) :'(
Logged

kiwimodeller

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 622
  • Location: Waihi, New Zealand
Re: Rainbow J-Class Yacht Build
« Reply #26 on: October 09, 2008, 08:53:33 pm »
That is a great help thanks, more use than anything I have found in months of looking. I gave up on scanners when the third one in three years clapped out but from your photos I can get dimensions easily enough. I will not be going in to great detail but just want to put the major bits, cabins and skylights, wheel etc in the right places. Cheers, Ian.
Logged

chocky 35

  • Guest
Re: Rainbow J-Class Yacht Build
« Reply #27 on: August 27, 2009, 07:04:55 pm »
dear ron, really like your rainbow j class ,how do you manage to bend the wood on the hull ,i have tried  a steam gun but kept splitting, any suggestions,thanks phil
Logged

ronkh

  • Guest
Re: Rainbow J-Class Yacht Build
« Reply #28 on: September 02, 2009, 07:19:50 pm »
Chocky 35,

Hello mate.
Sorry about the late reply.
Yes, I did steam some of the planks and some I used a plank bender that I got from some model shop. I forget which one but if you need the address, I am sure I could post it for you. The only thing with the bender is that it does leave a mark on one side and if you press too hard, you quite easily get a mark on the side that is on show.
Hope that helps a bit.

Ron.
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Page created in 0.165 seconds with 22 queries.