Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Graupner Voith unit  (Read 2470 times)

dms toucan

  • Guest
Graupner Voith unit
« on: November 06, 2009, 11:40:10 pm »
I need to put grease into the unit, how do you open it
without breaking it. Hope you can help
Regards Martin 
Logged

poll

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 940
  • Location: Pontefract, West Yorkshire.
Re: Graupner Voith unit
« Reply #1 on: November 06, 2009, 11:46:38 pm »
Hi Martin

The water lubricates the unit, when you take it out of the water after a run, you should run the unit a couple of secs to empty the chamber. Hope this helps.

John.
Logged

Umi_Ryuzuki

  • Guest
Re: Graupner Voith unit
« Reply #2 on: November 07, 2009, 09:57:24 am »
If I recall correctly,

Remove the belt from the drive pulley, then remove the small set screw in the top.
You can then unscrew the large drive pully from the unit's "drive shaft"...
It should just disassemble after that.
Logged

dms toucan

  • Guest
Re: Graupner Voith unit
« Reply #3 on: November 07, 2009, 02:14:53 pm »
Thank you Umi
Regards Martin
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.097 seconds with 22 queries.