Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Brass to Plastic  (Read 2262 times)

sinjon

  • Sinjon
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 351
  • Model Bioat Mayhem Forum is the Best!
  • Location: Stoke-sub-Hamdon, Somerset, TA14 6UF
Brass to Plastic
« on: April 20, 2010, 12:02:22 pm »
Advice please.

What is the best adhesive to use when attaching an etched brass fitting to plastic ?

Colin
Logged
Colin

Niall

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 173
Re: Brass to Plastic
« Reply #1 on: April 20, 2010, 02:08:45 pm »
I use super glue. Specifically the medium grade supplied by -
http://www.starloc.eu/

I also use their activator applied with a cocktail stick.
Logged

DickyD

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,423
  • www.srcmbc.org.uk
  • Location: Southampton UK
    • SRCMBC
Re: Brass to Plastic
« Reply #2 on: April 20, 2010, 02:18:44 pm »
As Niall says, medium superglue, I use Zap a Gap. :-))
Logged
Richard Solent Radio Controlled Model Boat Club http://www.srcmbc.org.uk

sinjon

  • Sinjon
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 351
  • Model Bioat Mayhem Forum is the Best!
  • Location: Stoke-sub-Hamdon, Somerset, TA14 6UF
Re: Brass to Plastic
« Reply #3 on: April 20, 2010, 02:28:52 pm »
Thanks Niall/Dicky,

Now I can get back and start assembling.

Colin
Logged
Colin
Pages: [1]   Go Up
« previous next »
 

Page created in 0.026 seconds with 21 queries.