Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Antje  (Read 2319 times)

Dabblingduck

  • Shipmate
  • *
  • Offline Offline
  • Posts: 3
  • Model Boat Mayhem is Great!
  • Location: cumbria
Antje
« on: February 24, 2013, 09:30:57 am »
I am new to the forum: for a number of years (20?) I have had a  kit for a Robbe "Antje" in the attic  the time has come to build it  the first operation, to my horror as a novice, is to trim the hull and deck mouldings  . any advice on the best way to do this would be gratefully received  it is not clear from the instructions  which "line" is referre to for the trim.
I am concerned that my first cuts might rin the whole job.
Many thanks in advance for any guidance   I have plenty of time and just want to get it reasonably right  (Combria based) 
Logged

tigertiger

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 7,820
  • Location: Kunming, city of eternal springtime, SW China.
Re: Antje
« Reply #1 on: February 25, 2013, 07:34:51 pm »
A couple of photos may help you get a response, as many builders will not have done the Antje, but could advise if they can refer to something.


Photos of hull and the relevant page of the instruction book may be a good place to start.
Logged
The only stupid question is the one I didn't ask

Dabblingduck

  • Shipmate
  • *
  • Offline Offline
  • Posts: 3
  • Model Boat Mayhem is Great!
  • Location: cumbria
Re: Antje
« Reply #2 on: February 26, 2013, 09:18:06 am »
Thank you. I shall do as you suggest.
Logged

tigertiger

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 7,820
  • Location: Kunming, city of eternal springtime, SW China.
Re: Antje
« Reply #3 on: February 26, 2013, 09:25:51 am »
Also have a look in the club section and see if there is a club near you.


Go along and ask.
Logged
The only stupid question is the one I didn't ask

hmsantrim

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 733
  • Location: U K
Re: Antje
« Reply #4 on: February 26, 2013, 02:52:07 pm »
 
  Hi Dabblyduck.
                           something to keep you busy.
     
                 http://www.google.co.uk/search?sourceid=navclient&hl=en-GB&ie=UTF-8&rlz=1T4GGHP_en-GBGB453GB454&q=robbe+antje+build
 
             Frank.  :P
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.883 seconds with 19 queries.