Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length.

[wicker]

anybody know where I can get brass strip about 3mmx0.5 for stantions

[longshanks]

One source    http://www.squirestools.com/12-19a.pdf
Scroll down to page 19

F1X4 Special Shapes Strip A: 1/64" x B: 1/8"............... £1.95

By my calculations that equates to 0.4 x 3.2mm

Hope this helps

[BrianB6]

Most model shops have K & S brass sections that includes flat bar.
Thicknesses from 1/64" upward and widths 1/16" to 2"

[wicker]

Thanks I will have look around on here as the nearest model shop that is in to boats is 200 miles from me-- thanks again--Charlie

[david48]

Hi wicker
If you look in R&D tugs and working there is a picture of some stanchions I had done at PPD at Lochgilphead . Thy are 3hole stanchions top hole takes a .75 mm wire and the other 2 take a .50 mm wire . Thy have the art work so it could be changed for your job . There is well over a 1000 on a A4sheet.
David

[boat captain]

One source    http://www.squirestools.com/12-19a.pdf
Scroll down to page 19

F1X4 Special Shapes Strip A: 1/64" x B: 1/8"............... £1.95

By my calculations that equates to 0.4 x 3.2mm

Hope this helps

That's the strip I use for my flat stanchions.  Really looks the part.

Joe

[wicker]

Thanks to all you good lads for your help- Charlie

[Paxton]

I was thinking about material such as this for my stanchions.  What is the most practical method for drilling out the holes for the wire - Pin vice?  That would be onerous for more than 20 or so.

[boat captain]

I was thinking about material such as this for my stanchions.  What is the most practical method for drilling out the holes for the wire - Pin vice?  That would be onerous for more than 20 or so.

 Make a jig and drill them preferably with a pillar drilling machine.

Joe

[wicker]

Joe that is just what I was planning to do or get a A4 sheet of etched stantion--Charlie

[david48]

 Hi wicker.   
What size are you wanting I might have some left of my job ,the one's I am using are 14mm 3 hole
David

[wicker]

I was needing 20mm 3 hole  - -  -  I will make some or go to ppd lochgilphead and try them but they need a computerise drawing

[david48]

Hi wicker
Have you talked to them I sent a drawing by post and they then did the art work it was all very easy. The reason I sent the drawing by post was I could not get it on the right file format to email them.
David

[Paxton]

Make a jig and drill them preferably with a pillar drilling machine.

Joe

Thanks Joe.  I'll give it a try.
 
Cheers
 
Don

[wicker]

I spoke to them and they said I would have to supply the drawing but I must recheck the size tomorrow and i will let you know if you size will do  thanks again for your help - Charlie