Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: I need a measurement, Please.  (Read 2185 times)

jpdenver

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 514
  • Just an old fart.
  • Location: Denver, Colorado USA
I need a measurement, Please.
« on: August 24, 2015, 11:16:00 pm »
Greetings,

I finished my Borkum, and I am not quite ready to scratch build.
I still want to do an open launch, so I am looking at the Victoria from Krick.

Can a current Victoria owner please take a measurement for me?

1. How long is the engine compartment - from tip of Propellershaft to Bow Bulkhead.
2. How wide at the propeller shaft -
3. How wide at the Bow Bulkhead.

(OK it is three measurements)

Much appreciated,

Jim Pope
Denver

Logged
Son of a Son of a Sailor.

xrad

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 603
  • Keeper of the Sun Dried Tomato
  • Location: Ohio USA
Re: I need a measurement, Please.
« Reply #1 on: September 13, 2015, 04:14:25 am »
 Spec : Scale 1:10 Length : 1077mm Beam 253mm

If you get  top/side views, you could estimate some of the measurements...

On my Alexandra:
Stuffing tube diameter is .275 in , shaft diameter at prop threads is about .155 in (outside thread angle)
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.162 seconds with 18 queries.