Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length.

[ttony47]

Hi all im considering buying a cem motor 750s , but can only find a motor mount 700 , is it lightley to fit , any on have any ideas .


                      Thanks Tony

[CGAux26]

I make motor mounts from aluminum angle material, bought from the hardware store.  One 36" piece makes many motor mounts.

[ttony47]

Thanks good idea but rather think the trip to the hard ware store texas may out weigh the cost hehe

[gregk9]

You may just have to "adjust" the holes where the mounting bolts go through in to the motor , [ If at all].

[Kipper]

According to the blurb on the C.M.B. site, the motor is just a "high power 700", so the mount they sell (Part No: AM700) should do the job.

[ttony47]

Thanks guys for the advice

[mike_victoriabc]

Have a look in your kitchen and borrow the aluminum cookie sheet - motor mounts, brackets - cuts easily.

[warspite]

Our cookie sheets are not usually ali, coated pressed steel is the norm, unless you go specific then maybe an ali one can be found.

[mike_victoriabc]

Think the couple I put aside are older before all the coatings became common.

[chipchase]

Hi all im considering buying a cem motor 750s , but can only find a motor mount 700 , is it lightley to fit , any on have any ideas .


                      Thanks Tony

Same Motor mount for both motors Tony

[ttony47]

Many thanks to all for you response

[Trawlerman-Les]

I bought a very strong mount ( 3mm aluminium ) for the CEM 900T motor I'm fitting in my Boston Typhoon from Cornwall Model Boats. Excellent mount. They also sell one for the 700 motor. Look for AMP mount.

Les