Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Vice for Dremel Work Station  (Read 4833 times)

Sonparc

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 58
Vice for Dremel Work Station
« on: October 04, 2007, 09:21:06 pm »
Hi All

I have been looking for some time for a low,flat vice that attachs to the base of the Dremel work station but so far without success.Can anyone please point me to a supplier ?

Sonparc
Logged

Red_Hamish

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 117
  • Have a wee dram and enjoy life
  • Location: Shetland (South Mainland)
    • Edinburgh Model Boat Club
Re: Vice for Dremel Work Station
« Reply #1 on: October 05, 2007, 08:41:12 pm »
Hi there , have a look at this link http://www.dremeleurope.com/dremelocs-uk/Product.jsp;jsessionid=4226A7C1ACFE5206F86EED10E19D215A?&ccat_id=527&prod_id=331 for a work holding vice from Dremel.
Try your local independent ironmonger or tool store for special orders.

cheers

Jim
Logged
Visit www.paddleducks.co.uk & www.edinburghmodelboatclub.org.uk for all your model boating needs!
See what life is all about www.visitshetland.com/sumburgh-airport-live-video This is the pace of life that the doctors prescribe, so laid back that you

Telstar

  • Guest
Re: Vice for Dremel Work Station
« Reply #2 on: October 06, 2007, 03:16:41 pm »
Hi     I may have missread your request but, I think what your looking for is a machine vice, to hold jobs when drilling etc.
Most good tool or hardware shops will have these or try the usual internet sources, E.G
http://www.cromwell.co.uk/ATL4451040K
Hope this helps
Tom
Logged

DickyD

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,423
  • www.srcmbc.org.uk
  • Location: Southampton UK
    • SRCMBC
Re: Vice for Dremel Work Station
« Reply #3 on: October 06, 2007, 03:58:24 pm »
Logged
Richard Solent Radio Controlled Model Boat Club http://www.srcmbc.org.uk

DickyD

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,423
  • www.srcmbc.org.uk
  • Location: Southampton UK
    • SRCMBC
Re: Vice for Dremel Work Station
« Reply #4 on: October 06, 2007, 04:11:10 pm »
Expo drills and tools do one.

http://www.expotools.com/

Click on MINIATURE POWER TOOLS & ACCESSORIES
Then click on 10 on item Drill Vices 10 & 33

 O0
Logged
Richard Solent Radio Controlled Model Boat Club http://www.srcmbc.org.uk

Sonparc

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 58
Re: Vice for Dremel Work Station
« Reply #5 on: October 09, 2007, 09:55:20 am »
Hi All

Thank you gentlemen for your suggestions,as usuall there is someone out there who knows!

Sonparc
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.019 seconds with 18 queries.