Topic: Single Cylinder Stem Engine - Identification (Read 1817 times)

DBS88 · « **on:** June 04, 2020, 03:35:25 pm »

Hi This single cylinder steam engine had not been used for years and was seized, it now rotates freely, the bore is cast iron and is immaculate, so I am renovating it and would like to know more about the engine, your thoughts about its manufacturer and construction are most welcome. It is 4 inches tall with a 5/8 inch bore and stroke. Thank you

ooyah/2 · « **Reply #1 on:** June 04, 2020, 04:23:38 pm »

It's an A.J.Reeves TROJAN with a home designed boiler water feed pump.
George.

frazer heslop · « **Reply #2 on:** June 04, 2020, 05:59:46 pm »

A write up for the updated version
http://www.model-engineer.co.uk/sites/7/documents/trojan-mk2-part1.pdf

DBS88 · « **Reply #3 on:** June 05, 2020, 06:38:34 pm »

George and Frazer, thank you for identifying this engine and for the additional information, your assistance is very much appreciated.
Theres a few bits and pieces to tidy up on the engine, before I run it. I am looking forward to running it so that I can learn from the pump set up. The pump set up is similar to what I am going to install in my new build, so it will be good to gain some practical experience of it and setting the bypass valve to achieve reasonable run times.

KNO3 · « **Reply #4 on:** June 28, 2020, 01:14:12 pm »

It looks like the Trojan but is not identical: the base is different, it only has 3 columns instead of 4 etc.

News:

Author Topic: Single Cylinder Stem Engine - Identification (Read 1817 times)

DBS88

Single Cylinder Stem Engine - Identification

ooyah/2

Re: Single Cylinder Stem Engine - Identification

frazer heslop

Re: Single Cylinder Stem Engine - Identification

DBS88

Re: Single Cylinder Stem Engine - Identification

KNO3

Re: Single Cylinder Stem Engine - Identification