Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: What is this ??  (Read 1374 times)

TheLongBuild

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 4,848
  • Build em, and play hard..
  • Location: Everywhere, But Nowhere !! But mainly in England....
    • Runcorn & District Scale Model Boats
What is this ??
« on: June 18, 2025, 05:12:09 pm »
So going through my draws of stuff I have bought but can not remember why or for what was hoping someone might know what they are.
Picture 1, all came out of the SHG box, the rubber grommets have shg stamped on them.


Pic 2 & 3, possibly a JJC product
Looking again i suspect pic 2 is a mini ships radar controller,  to be used with a stepper motor?


Pic 3 other than maybe jjc, no idea. %%
Logged

mrzippy

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 358
  • Location: Leicester, Midlands
Re: What is this ??
« Reply #1 on: June 18, 2025, 06:45:25 pm »
Top pic is an SHG ic. engine mounting kit.
Logged

TheLongBuild

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 4,848
  • Build em, and play hard..
  • Location: Everywhere, But Nowhere !! But mainly in England....
    • Runcorn & District Scale Model Boats
Re: What is this ??
« Reply #2 on: June 18, 2025, 06:59:52 pm »
Yes, but are they all the correct piece's,  I take it the round bits with the small holes are glassed into the hull ?, should there be 4.
Have searched but not yet found any pics.
Logged

mrzippy

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 358
  • Location: Leicester, Midlands
Re: What is this ??
« Reply #3 on: June 19, 2025, 07:19:53 am »
From my experience I used 4 posts glassed in -
found an advert on ebay for the smaller SHG 'Shadow' 3.5cc kit with similar parts showing 2 mounting posts used.

https://www.ebay.co.uk/itm/356448334703
Logged

Dave_S.

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 558
  • Member of the Mid Thames Model Boat Club
  • Location: Near Witney
Re: What is this ??
« Reply #4 on: June 19, 2025, 09:13:00 am »
I have had several Shadows, my current one was bought part built, but the engine mounts as shown in the first picture were already bonded in place. Wasn't too difficult to remove them ready for a brushless motor in place of the original glow engine. My first Shadow about 40 years ago had a Webra .20 for power, went quite well.
Logged
Ruining perfectly good kits since 1966.

TheLongBuild

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 4,848
  • Build em, and play hard..
  • Location: Everywhere, But Nowhere !! But mainly in England....
    • Runcorn & District Scale Model Boats
Re: What is this ??
« Reply #5 on: June 19, 2025, 02:54:13 pm »
Interesting, thanks for the info..
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.239 seconds with 21 queries.