Model Boat Mayhem
Mess Deck: General Section => Chit-Chat => Topic started by: ando on August 05, 2008, 12:20:06 am
-
hi i am quite new to this hobbie
i know that the inlet tube sit,s behind the prop and then on to the coil but were is the best position to site the outlet tube ( fitting ) ????
If two motor used !! yes i know inlet near prop !! but do i need to site both outlet tubes ( fittings ) together ???
Regards Ando
-
On a single motor setup, you go straight out the side of the boat, 90 degrees to the motor, With two motors, you can either go for two outlets, one either side of the boat, or both outlets on one side of the boat, again, straight out from the motors
-
hello thanks for the info O0 :)