Model Boat Mayhem
The Shipyard ( Dry Dock ): Builds & Questions => Working Vessels => Topic started by: emarald on July 08, 2009, 05:54:00 pm
-
re-doing the bow thruster on my aziz i bought awile ago it's loose and turns up and down over 45 degrees i cant get it out so i have to glue it in sittu but not sure if i can make it water tight by getting the glue all the way round and the space is tight any body got sugestions on what to glue it with and to make it water tight thanks
-
Perhaps some 30 or 45 minute epoxy thinned with denatured alcohol.
Mix the epoxy, then thin it till it is thin enough to brush into the area around the
thruster. Rotate the thurster assembly a few times as you do this.
The thinned epoxy should wick its way around and into the contact area
between the thruster tube an hull.
:-)
-
thankyou very much Umi_Ryuzuki most helpfull will give it ago