Model Boat Mayhem

Mess Deck: General Section => Chit-Chat => Topic started by: dms toucan on November 06, 2009, 11:40:10 pm

Title: Graupner Voith unit
Post by: dms toucan on November 06, 2009, 11:40:10 pm

I need to put grease into the unit, how do you open it
without breaking it. Hope you can help
Regards Martin 

Title: Re: Graupner Voith unit
Post by: poll on November 06, 2009, 11:46:38 pm

Hi Martin

The water lubricates the unit, when you take it out of the water after a run, you should run the unit a couple of secs to empty the chamber. Hope this helps.

John.

Title: Re: Graupner Voith unit
Post by: Umi_Ryuzuki on November 07, 2009, 09:57:24 am

If I recall correctly,

Remove the belt from the drive pulley, then remove the small set screw in the top.
You can then unscrew the large drive pully from the unit's "drive shaft"...
It should just disassemble after that.

Title: Re: Graupner Voith unit
Post by: dms toucan on November 07, 2009, 02:14:53 pm

Thank you Umi
Regards Martin