Model Boat Mayhem

Technical, Techniques, Hints, and Tips => DC Motors (Brushed) and Speed Controllers => Topic started by: olly4950 on September 22, 2013, 09:14:03 pm

Title: P94 DUAL ESC/MIXER MULTI CONTROLLER
Post by: olly4950 on September 22, 2013, 09:14:03 pm

Can anyone help please?
I first connected this setup to 2 550 motors only for the low end speed to be eratic. It was suggested on this forum that I change to the JP 480 motors, which I have only for the same thing to happen again. All motors have been suppressed.
The P94 has been sent back to Componet shop only for them to say all was ok.

I have the same setup in a lifeboat controlling 2 Deceperms with no suppression and these work fine.

What can I do to stop this happening?
Regards
olly4950

Title: Re: P94 DUAL ESC/MIXER MULTI CONTROLLER
Post by: seathug on June 24, 2014, 02:41:45 am

And im thinking of ordering this p94 for my robbe geared motors
and p93 for my bow thruster
Have you tried high speed?

Title: Re: P94 DUAL ESC/MIXER MULTI CONTROLLER
Post by: colin-d on June 25, 2014, 10:01:12 am

in all of the P94's that i have installed or used... i have not had this problem... then again i/we use multi pol motors in other words more than three pol... normally five - eight
 
i would imagine that your motors are three pol..?? and the magnet is probably reasonably strong, this might be one cause..!!