Model Boat Mayhem

The Shipyard ( Dry Dock ): Builds & Questions => Steam => Topic started by: jpdenver on August 24, 2015, 11:16:00 pm

Title: I need a measurement, Please.
Post by: jpdenver on August 24, 2015, 11:16:00 pm

Greetings,

I finished my Borkum, and I am not quite ready to scratch build.
I still want to do an open launch, so I am looking at the Victoria from Krick.

Can a current Victoria owner please take a measurement for me?

1. How long is the engine compartment - from tip of Propellershaft to Bow Bulkhead.
2. How wide at the propeller shaft -
3. How wide at the Bow Bulkhead.

(OK it is three measurements)

Much appreciated,

Jim Pope
Denver

Title: Re: I need a measurement, Please.
Post by: xrad on September 13, 2015, 04:14:25 am

 Spec : Scale 1:10 Length : 1077mm Beam 253mm

If you get  top/side views, you could estimate some of the measurements...

On my Alexandra:
Stuffing tube diameter is .275 in , shaft diameter at prop threads is about .155 in (outside thread angle)