Model Boat Mayhem

Technical, Techniques, Hints, and Tips => Radio Equipment => Topic started by: EJL on December 16, 2015, 06:08:48 pm

Title: JJC sound units
Post by: EJL on December 16, 2015, 06:08:48 pm

Currently sorting out the electrics etc in  a club members boat. It has a JJC PE 310 unit with a PE310 satellite unit which I guess is the engine sound. It also has a  M104 satellite unit which is maybe the klaxon horn. Each of the three units has a a servo lead.
Am I correct in thinking that the servo lead from the master unit goes into the RX? which port? or does it go via a y link into a speed controller
Does the servo lead from the PE310 satelite unit go via a y lead to the speed controller?
Does the servo lead from the M104 satellite unit go directly into a switch port on the RX


If anyone has a set of instructions for this unit it would be very helpful.


Thanks.

Title: Re: JJC sound units
Post by: Umi_Ryuzuki on December 16, 2015, 06:21:18 pm

The master unit, engine sound, should go to the same channel as the throttle, Esc.

The servo lead for the slave unit should go to a switch or other channel on the reciever.
Here are the instructions for the slave unit.  :-)