Model Boat Mayhem
Technical, Techniques, Hints, and Tips => Radio Equipment => Topic started by: tizdaz on November 09, 2016, 01:53:38 am
-
Hiya guys,
Ive been looking at a couple of modules, one is for a steam effect & one for sound effect.
Both of which need to be connected to same channel on my RX (throttle) . How would the wiring for this be done?
Each module (Steam & Sound) has to be connected like this (please exscuse my diagram skills!):
Diagram (http://"http://[email protected]/wiring.jpg")
As you can see each terminal on the ESC & RX needs to have both the Steam & Sound Module plugged into it,how would this be possible?
Thanks
-
A Y lead?
Barrie
-
As Barrie says, a Y lead from the rx to each module.
Only one will need connecting to the esc.
Ned
-
You will need 2 y leads 1 to Rx 1 to speed control other leg to the second y lead and the other 2 legs to your sound and smoke unit.
-
Thanks guys, was thinking about that but wasnt too sure if it would work incase they conflicted with e/other, thanks again much appreciated :-)
-
HI Tizdaz
The boat captain is right.
One Y lead connects from the receiver to the ESC (speed controller) and to the other Y lead for the sound and steam module.
Canabus
-
I just noticed the diagram link wasnt working so here it is again
http://www.cherryhilldaynursery.co.uk/wiring.jpg
-
If the modules have a sraight through function,
One Y lead from rx to each module and a single
Lead to the esc from the the through connection
on either of the modules.
Going by the diag/description, this would suffice.
Ned