Model Boat Mayhem

Mess Deck: General Section => Model Boating => Topic started by: KOI on December 13, 2016, 08:47:20 am

Title: Aeronaut Queen
Post by: KOI on December 13, 2016, 08:47:20 am

Hi, was looking for some advice on the Aeronaut Queen kit build. I am due to start the build in the next week and am looking for advice on waterproofing the Hull. I would like to maintain the mahogany finish and am planning not to paint the lower section of the Hull.
My question is will varnish/ lacquer suffice as a waterproof agent for the outside and would thinned dope work on the inside. Any advice greatly welcomed

(http://aeronaut-direct.com/estore/images/a3080_queen_lg_1.jpg)

Title: Re: Aeronaut Queen
Post by: Martin (Admin) on December 13, 2016, 10:28:11 am

 
Here on MAYHEM:  http://aeronaut-direct.com/estore/images/a3080_queen_lg_1.jpg

Also on YouTube:  https://youtu.be/1356qJ3q8-E

Title: Re: Aeronaut Queen
Post by: timg on December 13, 2016, 06:55:02 pm

Hi KOI


I have had the same dilemma a few weeks ago,


follow the link to read the advice I was given



http://www.modelboatmayhem.co.uk/forum/index.php/topic,56433.0.html


Here's the result so far




good luck with the build,  my main advice is to wipe up any glue of any wood you want to varnish, although you probably know that


spud

Title: Re: Aeronaut Queen
Post by: KOI on December 20, 2016, 09:50:01 am

Hi Martin/ Spud, thanks for coming back and the advice.
I now think I will below waterline go for white, varnish the mahogany and use epoxy for inside.
few more questions if I can-

1. suggestions on process for white below the waterline
2. Varnish recommendations, I see quite a few people use International
3. Epoxy inside to seal, do people suggest Z poxy, or can I just use a cheap thinned epoxy to seal inside

Many thanks for any advice

Title: Re: Aeronaut Queen
Post by: terry horton on December 20, 2016, 08:07:02 pm

I've just finished one of these for a fellow member of the Swindon model boat and engineering club.
A super kit which goes together with the minimum of problems and built in three weeks of afternoons. in the shed
Interior waterproofed with two part resin, exterior finished with five coats of high quality satin varnish...  the owner feels it looks more in scale than a very high gloss finish.
Old English white below the water line with a fine ,pale green line separating the white from the mahogany.
Seats and roof finished in old English white


An excellent kit  and smart looking boat


Kind regards
Terry H

Title: Re: Aeronaut Queen
Post by: KOI on December 21, 2016, 08:32:09 am

Hi Terry, thanks very much for the detail on the finishing, very helpful.