Model Boat Mayhem
Mess Deck: General Section => Model Boating => Topic started by: jezzahealy on October 15, 2017, 08:44:23 pm
-
Hi,
I am planning on making a model of Mucho Gusto.http://www.classicwoodenboatplans.com/mucho-gusto/ (http://www.classicwoodenboatplans.com/mucho-gusto/) I have a Graupner Water Jet unit which I was planning of installing. It is the white and red water jet they produced.
I any advice on the water jet. Is there e vertical position which the water jet should be set to?
I recall reading somewhere, that the the shaft in the until should be on the water line when the boat is stationary in the water. Is this correct? If so could the hight of the unit be reduced, by removing some of the inlet to lower it in the boat?
Any advice would be greatly appreciated.
Jeremy