Model Boat Mayhem
Mess Deck: General Section => Chit-Chat => Topic started by: Martin (Admin) on March 14, 2018, 06:54:11 pm
-
What's the name / term for bending metal or fixture past the required end position because you know it's going to spring back to what you actually want?
.... overshoot?
-
I think if you overshoot that possibly means that you have gone too far?
If we are talking about bending metal for our purposes then for me the extra pressure is down to experience and feel for the job at hand.
The yield point of metal is when it’s stretched and reaches the point whereby if you stop it will return to its original state. If you pass the yield point the metal will not return to its original state. Breakage occurs shortly after.
Hope this helps
-
Compensation.
Electrical plastic conduit needs bending acutely to achieve a stable 90
-
What's the name / term for bending metal or fixture pass the required end position because you know it's going to spring back to what you actually want?
.... overshoot?
ELASTIC MEMORY COMPENSATION (Or am I thinking about gym time at secondary school)
-
Over bending is the term.
Chris
-
Yes, and it's hell on the knees.....
-
Yes, and it's hell on the knees.....
{-) {-) {-) {-) {-) .........know the feeling Colin,
-
... watched a Utube video this week, turns out, it is called 'Spring back'........ FYI ! ok2
https://youtu.be/aT8ET5t6f20?t=45