Model Boat Mayhem

Mess Deck: General Section => Beginners start here...! => Topic started by: Pragmatist on July 02, 2019, 01:42:56 pm

Title: Taranis X9D assign throttle problem
Post by: Pragmatist on July 02, 2019, 01:42:56 pm

So I’ve  managed to assign the rudder to the right hand stick successfully however I cannot get the motors turning. I apply throttle and there is a double bleep from the speed controller and the left hand motor turns a few mm’s then nothing. I know everything in the boat works properly so I’m guessing it’s just the complexities of the TX.

Title: Re: Taranis X9D assign throttle problem
Post by: kinmel on July 02, 2019, 06:54:29 pm

In model menu try the following first steps...

page 5/13 "INPUTS" set I01 to   100 01      sets channel 1 to 100% travel of input 01
page 6/13"MIXER" set CH1 to 100 01         sets CH1 to 100% mixing with 01

page 7/13 "outputs" set CH1 to name  0.0   0.0 100.0   sets output to positive values only
page 8/13 "curves" set CV1 to +100  0  +100   all movements of stick give forward power ( jet drive motors don't use reverse )

Title: Re: Taranis X9D assign throttle problem
Post by: Pragmatist on July 02, 2019, 07:10:23 pm

Thanks, will give that a try.