Model Boat Mayhem
Technical, Techniques, Hints, and Tips => The "Black Arts!" ( Electrics & Electronics ) => Topic started by: john44 on May 05, 2021, 03:26:15 pm
-
Hi guys, a friend of mine is trying to fit the above module to his Robbe F14 40 MHz transmitter
Has anyone fitted this 2.4 MHz module to their 40 MHz transmitter.
My friend cannot remember what he did with the wiring instructions so if anyone can help
He will be very grateful
John
-
Hi John,
Assuming it's like the module in the picture it's pretty simple
(https://modelboatmayhemimages.co.uk/images/2021/05/05/Orange.jpg)
The module only has 3 wire that can be connected - they are terminated in female sockets wrapped in black heat shrink - they will slip onto the header pins inside the F14
The colours are consistent with most RC equipment - like a servo
The supply voltage range is 6.0-15.0V
Orange = PPM signal
Red = + positive supply
Brown = - negative supply
(https://modelboatmayhemimages.co.uk/images/2021/05/05/d.jpg)
Oh - and this was the instructions in the box I had - just be careful with the " connectoted "!!!! :)
(https://modelboatmayhemimages.co.uk/images/2021/05/05/A.jpg)
(https://modelboatmayhemimages.co.uk/images/2021/05/05/B.jpg)
(https://modelboatmayhemimages.co.uk/images/2021/05/05/C.jpg)
Regards
C-3PO