Model Boat Mayhem
Technical, Techniques, Hints, and Tips => Engineering Techniques and Materials. => Topic started by: Tom@Crewe on June 26, 2006, 05:28:54 pm
-
I have a 1:40 scale hull and its smooth as a Babies Bottom, I want to detail it plating is not a big problem I think I'm ok with that.
But what about the rivets, have seen the tip on teddies eyes but they are to large for this scale.
Any tips.
-
I have used a syringe to deposit small drops of pva glue it worked very well and did not take as long as I thougjt it would.
Mark
-
where do you get a syringe that fine?
do you think I could us some brass rod dip it in a pool of PVA and transfer it to get the same result??
-
where do you get a syringe that fine?
do you think I could us some brass rod dip it in a pool of PVA and transfer it to get the same result??
I have done it that way, have a sharp end on your brass, I have also done it with a syringe, takes about the same time. ;D ::) ::)
-
I have used normal copier paper.
Cut to the correct plate size, use a suitable piece of brass rod to indent rivets from the inside, need to be careful, but it is only paper.
Paint pva glue on the inside of the plates and stick on to hull. Let it all dry out and paint over the outside with pva.
The glue does fill in the dents for the rivets, the pva waterproofs the paper and prepares for a coat of paint too!!
It worked for me.
Bob
-
I use old clock wheels mounted on a simple handle. File off unwanted teeth to give the required spacing. Run the wheel over the material you are using with a steel rule as a guide. I have used thin plasticard and paper either in plate form, as in Shipmate's post, or in narrow strips.
A selection of different size wheels will cover most jobs. As a lot of these have very sharp teeth a rub over with a file may be needed.
-
I have done a test piece, I used thin card and the results are great, this is the way to do the whole hull
Thanks for the tip..!
-
Try applying rivets using thick super glue and a cocktail stick! It works a treat, when all is dry, lightly sand down the tops of the dried super glue rivets and then your ready to paint. I got the idea from an issue of model boats, it was the issue that had a build up of the mini Bluebird inside.
Be prepared to go a little nuts doing it :P
-
If using the "clock" or Dress makers wheel method for riveting may I suggest that you do the rivets so they show as "indents" on the final hull. This way you will not obliterate them when rubbing down the final hull. Also, the human eye cannot easily distinguish between "in" and "out" when light hits them.