Model Boat Mayhem
Technical, Techniques, Hints, and Tips => Detail Work, Rigging, Fittings, Figures Etc. => Topic started by: byfly on September 22, 2008, 03:19:09 pm
-
Could someone please give me some ideas about how to simulate rivet heads in an engine house roof on a tug that I'm building. I've tried the dry glue blobs (epoxy and white glue) but I find it difficult (impossible) to get the blob size identical each time. I thought about using round headed panel pins but cannot find a supply. Any ideas would be gratefully received
-
Pin supplier. O0
http://www.alwayshobbies.com/Store/Craft-Materials/Fixings-and-Hinges/Fret-Pins/Brass-Fret-Pins
-
Hiya,
I do'nt know what scale you want but this site
www.modellingtimbers.co.uk/4604/74734.html
have brass rivets 0.5mm thick and 3.0mm long.
Keith.
-
I have used superglue gel with success. I put the drop on the primer and when all dry paint over. You do need patience and a little practice to get it looking ok.
Ian
-
I'm a firm supporter of the "Pounce wheel" method. Get yourself an old clock gear or the appropriate pitch, mark out a piece of card with the lines of rivets and off you go. Just run the wheel up the lines, turn it over, a quick coat of varnish and you've got yourself a riveted roof.
Rick
-
Byfly,
My own prefered method for simulating rivet heads is to use a syringe with a square cut needle and i use pva wood glue un-thinned
Dont worry if you make a hash of it as you can wipe them straight off with a damp cloth and try again!
It does take a bit of practiceand a steady hand but you can get very good consistant sized heads and once dry just over paint...job done
Cheers
Ian
-
i have for a few years now used a fabric "paint" that i buy from a haberdashery/art and craft shop.
it is made to go onto fabrics to make high lighted areas and dries quickly and hard.
it is fed through a very thin nozzle and is attached to the article by capilliary attachment. it gives perfect uniform rivets every time. O0
-
I`d second the pounce-wheel method, depending on which scale you are you can use the wheel which is in the sewing box of your wife. Works any good for me- if you want to take a look under my posting for the Sir Lancelot:
http://www.modelboatmayhem.co.uk/forum/index.php?topic=11157.0
Happy modeling,
Jörg
-
Would you use coloured glue?