Model Boat Mayhem
Technical, Techniques, Hints, and Tips => Engineering Techniques and Materials. => Topic started by: monarch on May 17, 2009, 10:12:16 am
-
Hi All
Does anyone know where I can get 1.7mm dia stainless rod. Need to tap ends 10ba to fit servo linkage but can't find anywhere that sells the stuff.
(http://www.postimage.org/templates/images/smiley/doh/0.gif) (http://www.postimage.org/)
-
Cornwall Model Boats sells M2 steel rod already threaded for standard servo linkage, any good ?
http://www.cornwallmodelboats.co.uk/acatalog/installation_accessories.html
-
Contact Mike Mayhew at Waverley Models. He has sent me some offcuts in the past which are pretty much that size.
FLJ
-
Is there any fabrication workshops around you, TIG stainless steel welding rod comes in 1.6mm so you could get some for free.
riggers
-
Try yer local welding shop that does Stainless fabrications, they should have various grades of straight rods. Usually about a metre long.
Regards Ian
Beat me to it Riggers, yours was holding mine from Posting {-) :-))
-
Bike spokes
Proteus
-
1.7mm = 0.0669" while 1/16" = 0.0625. That's a difference of 0.0044" and given that stock metal is rarely spot-on in size, is unlikely to make any difference at all to a 10BA thread. Try Folkestone Engineering Supplies at www.metal2models.btinternet.co.uk for 1/16" stainless at 45pence/300mm. I've always had good service from him.
Cheers,
Barry M
-
Try yer local welding shop that does Stainless fabrications, they should have various grades of straight rods. Usually about a metre long.
Regards Ian
Beat me to it Riggers, yours was holding mine from Posting {-) :-))
Good minds think alike ;)
-
Hi All
Thanks for all inputs, the 1/16" stainless will do fine.
Seems allmost impossible to get 1.7mm anyway.
Just got to wait for my lathe to arrive and by a tailstock die holder then job done.
Cheers all :-))
-
Monarch
I have some stainless TIG rods how many do you want?? PM me with your address if you want some
Brian
-
bri will those tig rods go through the holes on regular servo arms?
-
Yep
-
can ya bring a rod to wicksteed please.
-
No problem how many you want??
-
enough to make a two pc rod to cover 4" and allow for adjustment, so i think 2x 6" ones will do please