Model Boat Mayhem
Mess Deck: General Section => Tugs and Towing => Topic started by: FIRPARK on February 18, 2010, 08:31:46 pm
-
Hi--Can anyone please help with a drawing or detailed photo of the fire monitor used on the Moorcock. It may have been a Merryweather, but the drawings I have are very poor and lack detail. It appears to two hand wheels--was one to control the water flow, and the other for the monitor angle?
Thanks
firpark
-
I Have cropped this from a picture of the Hibernia I hope it helps, but in practice they were always kept covered unless wanted .Hibernia's faced aft and the Avenger's faced foward.oncethe two were painted in the same livery.
-
Here is another one a bit grainy I am afraid
-
Hi
Thanks very much for comming back to me so quickly, the photos have been a great help. The monitors look to have one wheel valve for water flow-- low down on the stanchion. Would you think that the upper wheel locked the monitor rotation? How did they control the elevation?
Thanks again for your help
firpark
-
Halfway down the Riser was a geared electric motor you can just make out the watertight covers, this controlled rotation from the wheelhouse, once elevation was set the platform was cleared, a bit old fashiond but not bad for the times.
-
Hi--Can anyone please help with a drawing or detailed photo of the wheel house and bridge on the Moorcock. I expect that it would have had Radar-Decca-Depth finder-- long and short wave RT sets etc.--but where would they have been fixed? Can someone please let me know where I can get, or how to make small 1-24th--radar screens-radio dials-compass cards etc?
Thanks
firpark