Model Boat Mayhem
Technical, Techniques, Hints, and Tips => The "Black Arts!" ( Electrics & Electronics ) => Topic started by: Timo2 on February 28, 2010, 11:59:46 am
-
Hi All
Look for two ( 2 ) old type Futaba plugs ( Pin ) to fit FP-R2GS,
Timo2
P.S.
Trying to help young lad ( 12 ) for his first Model :-))
-
Might be able to help. Got any cupboards? %)
FLJ
-
Timo
Can I ask what you want the plugs for? I have lots of old Futaba stuff in the loft
and it would help if I knew what you want.
Cheers
Mark
-
Hi Mark
The old pin type eg. O0
Timo2
-
Timo2
I think I have a couple still with servos on, any use?
-
I "converted" one using pins made from nickel silver wire (handrail wire left over from railway modelling). The small offset was no problem - it just gave a bit of tension that ensured good contact.
Just a case of cutting three bits of wire about twice the pin length, inserting them into the RX socket holes, et voile, an RX with pins to plug an up to date device. Repeat for the other channel.
It is possible that the RX, because of its age, does not possess the same selectivity as a modern one ( theres lots more "legal" channels squeezed into the same bandwidth today) so it MIGHT suffer from cross-channel interference.
-
Timo2
Like Phil I have a number of servos and switch harnesses.
Would be a shame to chop the plugs if we can help with the stuff you want.
Mark
-
Thank You All
and a big THANK YOU to Steamboatphil :-))
Good to meet on Sunday at South Shields show
Timo2
-
Might be able to help. Got any cupboards? %)
FLJ
Well that's your Medi Cruise cancelled for this year! {-)
Barry M