Model Boat Mayhem
Technical, Techniques, Hints, and Tips => Detail Work, Rigging, Fittings, Figures Etc. => Topic started by: bbdave on November 03, 2011, 09:36:55 pm
-
Hi i am looking for some small diameter couplings they're not for a prop shaft i'm sure i've seen some small brass ones somewhere but just can't remember where or who was selling them even a ball dogbone type could do i do need a definate pivot point.
but they can only be around 7mm O.D.
Dave
-
mustang mark sells them look up marks model boats on net or mustang mark on ebay hope this helps
-
bbdave if they dont need too much torque use a peice of silicone tube %%
-
I have had a look on MMBs site but they seem quite big i may try some tube on a test rig thanks for replies
Dave
-
I have had a look on MMBs site but they seem quite big i may try some tube on a test rig thanks for replies
Dave
Send me a pm with what you need, we can make them whatever size you like :-))
-
Try the model car section of your hobby shop, they have some very nice small drive joints.Looking at the date this may be a bit too late, but still O/K for someone else. Mick B.