Model Boat Mayhem
Technical, Techniques, Hints, and Tips => DC Motors (Brushed) and Speed Controllers => Topic started by: Tralee on March 28, 2007, 08:59:17 pm
-
I have recently purchased from Model Slipway a Drumbeat of Devon model kit.
I intend running this on two Graupner 600 Eco 7.2v motors, do these motors require supressors? and if so any help with type and supplier etc would be appreciated
-
This might help....
http://www.modelboatmayhem.co.uk/forum/index.php?topic=424.0 (http://www.modelboatmayhem.co.uk/forum/index.php?topic=424.0)
http://www.modelboatmayhem.co.uk/forum/index.php?topic=751.0 (http://www.modelboatmayhem.co.uk/forum/index.php?topic=751.0)
-
Hi Trailee
Its is advisable to install all motors with suppressors you will req 3 in total one between the motor terminal's and the other 2 from each motor terminal to motor can. the value of these should 104 pf any good model shop should have these in stock if not contact all components on 01981 540781 also very good for small bulbs and cable also hope this helps. Do you have a Maplins shop in your area if so you will be able to get them there. :)
Stan
-
Hi Trailee
Fogot to tell you type of capacitor s you will req ceramic or ceramic dipped also i think you may be able to get these from S.H.G model supplies. :) :) :)
-
Hi Trailee
most of the graupner motors i have come across have internal suppressors.
But if you are not sure then I dont think that fitting another set will hurt,
but then someone on here will correct you if I am wrong.
ro88o