Model Boat Mayhem - Forum

Technical, Techniques, Hints, and Tips => BRUSHLESS Motors and Speed Controllers => Topic started by: scout on March 30, 2012, 12:04:21 PM

Title: mtronics wire broken
Post by: scout on March 30, 2012, 12:04:21 PM
I have an mtronics speed controler one of the thin wires ( the one nearest the case ) to the on off switch has broken off just as it enters the case put any heat near it and the case just bubbles up any ideas if it can be mended or just bin it Yours Scout
Title: Re: mtronics wire broken
Post by: john s 2 on March 30, 2012, 03:19:18 PM
The only thing that comes to mind is to gind off some of the resin and resolder. or hammer a pin in glue in place then solder to that. You know doubt no Mtroniks do do a repair service. John.
Title: Re: mtronics wire broken
Post by: bikerdude999 on March 31, 2012, 06:18:34 AM
Mtroniks do have a repair service, its on their site somewhere, if you can't find it just email them and they'll tell you about it. I emailed them and they sent me an address to sent the ESC to, along with a brief description of the problem with the ESC, i never did get round to sending it though...
Title: Re: mtronics wire broken
Post by: scout on March 31, 2012, 07:32:34 PM
Thanks I will give them a try Yours Scout
Title: Re: mtronics wire broken
Post by: scout on April 10, 2012, 03:34:28 PM
Does anyone have an email address as the one on their site enquiries@mtronics.net just comes back not known Yours Scout
Title: Re: mtronics wire broken
Post by: Netleyned on April 10, 2012, 03:54:33 PM
There is a Technical Helpline No. as well as the normal one.
Why not try that?

Ned