Model Boat Mayhem
The Shipyard ( Dry Dock ): Builds & Questions => Navy - Military - Battleships: => Topic started by: deerstalker36 on June 10, 2012, 08:58:13 am
-
Ok, first (ish) post....
i've been reading up on how to put the deck on my 1/96 Cherry B. I can see how to put a flush deck using a rim around the inside of the hull, but how would i make the rounded off deck edge of a leander. {:-{
would i fit a flush deck then add another layer slightly wider incorporating the round off of the deck?
cheers
Colin
-
It's probably the only deck that you would mount on top of the hull then round off.
Regards,
Apollo
-
Hi,
Put a balsa square block attached to the hull sides and deck at the desired height then just sand down to correct profile. Or plasticard.
Rich F87