Model Boat Mayhem

Technical, Techniques, Hints, and Tips => Other Technical Questions... => Topic started by: sailorboy61 on September 16, 2012, 11:22:16 am

Title: Graupner Water jet - Moonraker
Post by: sailorboy61 on September 16, 2012, 11:22:16 am
Well my second hand Moonraker has arrived, so trying to strengthen her up, fix a few broken frames and set up the motors.

It has 900BB Turbos installed, but one of the jet shafts has quite a bit of play, such that at one end it (presumably the prop part), touches and stops me turning the shaft. Obviously not too good, though probably can be set up with the coupling to stop this, but wondering if there is any adjustment to the shaft travel. Unfortunately I don't have the instructions.

Anybody with any experience of these and suitable advice?

Thanks.