Model Boat Mayhem
Technical, Techniques, Hints, and Tips => BRUSHLESS Motors and Speed Controllers => Topic started by: JamesD on October 16, 2013, 05:34:48 pm
-
Not sure whether i am in the right section.
Would like to convert my Najade to a brushless setup with esc and a couple of lipos,i am hoping someone on the forum as already done this,or can anyone tell me how to go about it,any help would be appreciated
James :-))
-
What motors do you currently have in it?
-
Hi Martin, its got the robbe stock motor 710/ ?
Cheers
-
looking at the spec of the motor you have on 12v it gives 15300 rpm so you will need a brushless motor with a KVA/volt of 1275/v this would give you the same revs as your set up now.
I obviously will stand corrected on this .
Dave
-
Do not do brushless yet so maybe some of the brushless guys could tell you about this motor I found in an advert for the Najade
The propulsion system is based on a ROXXY 3656-06 brushless motor driving the propeller direct via the propeller shaft;
-
That has a slightly higher KVA than the original ........BUT would be spot on for the boat anyway,as slightly more power is NOT a bad thing
Dave
-
That is the motor Robbe used when they went over to brushless.
-
I have a roxxy in mine
It goes fantastic, i have it attached to a big Lipo, goes for ages
Original prop, i thought about putting a bigger brass one on...but i dont think it needs it
I know people have moaned about a right hand lean, with proper ballast there is none
-
Hi Martin, its got the robbe stock motor 710/ 12
Cheers
-
A pal of mine has a Najade, with stock motors in , goes like stink,and the battery lasts for ages. I cant think why you would even want to change it?
Mick F