Model Boat Mayhem

Mess Deck: General Section => Chit-Chat => Topic started by: Edsteam on September 19, 2014, 09:58:44 am

Title: Stuart Turner Sun Plans/Drawings
Post by: Edsteam on September 19, 2014, 09:58:44 am
Hello,I have a set of Stuart Turner sun steam engine castings,has anyone a set of drawings for this engine.Thank's ED
Title: Re: Stuart Turner Sun Plans/Drawings
Post by: TurboTyne on September 26, 2014, 01:21:44 pm
Hi Ed

I've just dug out the drawings for the Sun. I also have a completed engine, although I cannot take any credit for making it - it was made by my late father.  The drawing is old - issue date is 1956 and I don't know if any changes were made to the design of the castings over the years since then.

If you are still looking for the drawings and you think these will be useful then I'll be happy to scan them and e.mail direct to you. Also, if you have any questions about the engine I'll do my best to help by examining the engine.

Regards

Mike
Title: Re: Stuart Turner Sun Plans/Drawings
Post by: Edsteam on September 29, 2014, 04:48:43 pm
Mike,thank's for your reply,if you can send a copy it would be much appreciated as they are no longer available from ST ,my email address is   *********

I (edseftons@aol.com.I) have built several Stuart Turner engines over the past few years they make a good winter project.

Thanks again Ed



Please do not put Email addresses on an open Forum as it's not advised.

To contact this member you can use the private mail system via Mayhem

ken