Model Boat Mayhem
Mess Deck: General Section => Tugs and Towing => Topic started by: Nellybob on May 31, 2015, 12:21:16 pm
-
It's been done to death here so I'll spare the details %%
-
Can never have enough Dickie tugs! any more pics of the full thing?
-
You can see her here:
https://vimeo.com/129316520
She's a bit listing but this was a ballast test and I put it right.
-
Why is one end clean and the other end dirty? :}
-
More pics.
-
She's undergoing a repaint and they decided to start at the front {-)
-
More pics, I'll post again when she's rustier and finished.
-
Duh!!
-
That's one dirty dickie.
Great job.
-
Adding more dirt and detail, and a mast.
-
Perhaps a few too many stickers?
Or a bit thick looking and clean? If those are the stickers available online on eBay and a few other sites (I forget the makers name) then what I did for my last build was get some very fine sandpaper and carefully sand the stickers down from the back. So you get rid of the glue and a bit of the backing paper.
This makes them a lot thinner and you can just secure them with a tiny smear of glue and they sit much more flush with the paintwork.
Just an idea.
Alex
-
Thanks Alex :-))
Also added scale crane , wee man and mast, job done :-)