Model Boat Mayhem

Technical, Techniques, Hints, and Tips => The "Black Arts!" ( Electrics & Electronics ) => Topic started by: Dave Cook on July 15, 2015, 12:41:51 pm

Title: JJC Electronic Sound Modual
Post by: Dave Cook on July 15, 2015, 12:41:51 pm
Hi All , A friend of mine as bought a brand new JJC Electronics sound slave card off Flee Bay . How ever once we read the instructions it was clear that a JJC Electronics Master Unit was required to run the slave card . JJC are no longer tradeing so thats not possible . I have since heard that the Master Unit was just a amplifier that could take up to 3 slave cards . Does anyone know of these sound units and of a amp that would do the job and how to wire it up .
The full name on the slave card is V8 Turbo slave card ( sounds amazing) it as a 3.5mm jack socket for out put and a lead for the receiver.
Best Regards Dave  :-))
Title: Re: JJC Electronic Sound Modual
Post by: Umi_Ryuzuki on July 15, 2015, 06:22:07 pm
See if you can use some jumper cables to connect the module to some amplified computer speakers.
If that works, you may be able to find a small amp module on Maplins, or maybe
just pull the board from a set of computer speakers and use that.


 :-)
Title: Re: JJC Electronic Sound Modual
Post by: Stan on July 15, 2015, 08:45:28 pm
HI Dave first of all a pm sent to you. The master unit was it self a sound unit with a built in amp other slave units could be plugged in to it via a cable. The sounds from the slave all came back to the master unit. JJC made a master amplifier for slave units I have two of these and they are very poor to say the least.  The power for the slave units was taken from the master unit via a cable  if you check you will see on the slave only a rx cable. give me a call and will explain in more detail.

Stan
Title: Re: JJC Electronic Sound Modual
Post by: timgarrod on July 15, 2015, 09:14:42 pm
Hi, I friend of mine asked me the same question on the weekend, as has two slave unit like above.

Thanks.